DeWalt DCD730-XE Manual de servicio

Busca en linea o descarga Manual de servicio para Taladros Eléctricos DeWalt DCD730-XE. DeWalt DCD730-XE Technical data Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir

Indice de contenidos

Pagina 1

www..euDCD730DCD735DCD780DCD785

Pagina 2

ENGLISH39Important Safety Instructions for All Battery PacksWhen ordering replacement battery packs, be sure to include the catalog number and voltage

Pagina 3

ENGLISH40 Read instruction manual before use. Charging. Fully charged. Hot/cold pack delay.x Problem pack or charger. Problem powerline. Do not pro

Pagina 4 - DCD735, DCD785

ENGLISH41Electrical SafetyThe electric motor has been designed for one voltage only. Always check that the battery pack voltage corresponds to the vol

Pagina 5

ENGLISH42NOTE: The first time the tool is run after changing the direction of rotation, you may hear a click on start up. This is normal and does not

Pagina 6 - EC-Declaration of Conformity

ENGLISH43To move belt hook or bit clip, remove the screw (h) that holds it in place then reassemble on the opposite side. Be sure to securely tighten

Pagina 7 - Drill/Driver/Hammerdrill

ENGLISH44NOTE: A smooth, even flow of dust from the hole indicates proper drilling rate.Screwdriver Operation (fi g. 6) 1. Select the desired speed/to

Pagina 8 - Battery Chargers

ENGLISH45advantage of this service please return your product to any authorised repair agent who will collect them on our behalf. You can check the lo

Pagina 9 - Hot/Cold Pack Delay

Belgique et Black & Decker - DEWALT Dutch Tel: 32 70 220 063 Fax: 32 70 225 585Luxembourg Nieuwlandlaan 7, IZ Aarschot B156 French Tel: 32

Pagina 10 - Storage Recommendations

1Figure 1abcdfeghikjhFigure 2kjl

Pagina 11 - Description (fi g. 1)

2Figure 3Figure 7ccfFigure 4 Figure 5 Figure 6Figure 8 Figure 9mn

Pagina 12 - EWALT battery

ENGLISH33CORDLESS COMPACT 13 mm (1/2") DRILL/DRIVERDCD730, DCD780CORDLESS COMPACT 13 mm (1/2") DRILL/DRIVER/HAMMERDRILL DCD735, DCD785Congra

Pagina 13

ENGLISH34 Vibration emission value ah Screwdriving ah,ID = m/s² < 2.5 2.5 < 2.5 2.5 Uncertainty K = m/s² 1.5 1.5 1.5 1.5The vibra

Pagina 14 - Instructions for Use

ENGLISH35EC-Declaration of ConformityMACHINERY DIRECTIVEDCD730, DCD735, DCD780, DCD785DEWALT declares that these products described under Technical Da

Pagina 15

ENGLISH36d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool

Pagina 16 - GUARANTEE

ENGLISH37 • Wear safety goggles or other eye protection. Hammering and drilling operations cause chips to fly. Flying particles can cause permanent

Pagina 17 - N173132 03/12

ENGLISH38 • Do not use an extension cord unless it is absolutely necessary. Use of improper extension cord could result in risk of fire,electric sho

Comentarios a estos manuales

Sin comentarios