DeWalt DWX724 Manual de instrucciones descargar pdf (Pagina 4)

Preparation (Fig. 2)

1. Place the miter saw stand on the ground with the

FIG. 2

folded legs facing up.

2. Depress the leg lock lever (J) or release button (K)

and pull leg up until the locking pin clicks into the

place. Repeat on each leg.

3. Lift the stand by the center beam and place it in an

upright position. The stand should be stable and

should not rock.

NOTE: Ensure all locking pins are engaged and the legs

are locked in place.

ASSEMBLY

DW7232-XE Workpiece Support and Length Stops (Fig. 3–4)

a. The work support/stop (D) has a clamp

FIG. 3

(L) to capture the beam and keep it

from being knocked off the beam by

your material. The knob (M) may be

locked by turning clockwise and the

work support/stop is free to be

repositioned when the knob is turned

counterclockwise. Do not overtighten,

firm pressure on the knob will hold the

stop in place.

FIG. 4

b. Adjust the height of the work support/stop (D) by loosening the knobs on both

sides (N) and raise or lower the top surface to align with a straight edge or level

to the saw table. Tighten the knobs.

NOTE: If the work support height adjustment slips down when under a load, the

weight limit of the work support has been exceeded. This weight limit is limited

by the tightness of the height adjustment knobs. Do not tighten more than finger

tight.

c. The work support/stop (D) can also be installed in the end cap (E) at the end of

the extension arms.

d. The length stop (O) may be rotated up to serve as a length stop or hold the end

of long workpieces.

Adjustable Length Extension Arm (Fig. 5)

To lengthen the support surface, turn the extension

FIG. 5

arm lock lever counterclockwise to release the

extendable extension arm. Pull the extendable

extension arm out to the desired length. Turn the

extension arm lock lever clockwise to lock.

DW7231-XE DEWALT Miter Saw Mounting

Method (Fig. 6, 7)

WARNING: To reduce the risk of injury, turn unit off, disconnect machine

from power source before assembling the miter saw to the miter saw stand. An

accidental start-up can cause injury.

WARNING: Stability Hazard. You must use the Universal Miter Saw Mounting

Method when mounting a miter saw not manufactured by DEWALT to this miter saw

stand.

WARNING: To reduce the risk of personal injury, be sure the miter saw is fully

anchored on the stand.

WARNING: For your own safety, read and understand the miter saw instruction

manual before using. Failure to heed these warnings may result in personal injury and

serious damage to the miter saw and the accessory.

1. Place saw in operational position with blade facing you. Align with label on the

mounting bracket showing front.

2. Place a spacer, such as a 2 x 4, under one side of the miter saw to hold the

saw’s mounting feet above the work surface.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

DeWalt DWX724 Manual de instrucciones Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares DeWalt DWX724