DeWalt DC841 Instrucciones de operaciones descargar pdf (Pagina 9)

!!! CAUTION !!!

BOTH UPPER AND LOWER GUARDS MUST REMAIN IN PLACE FOR SAFE CUTTING OPERATION.

Rotating the Motor to Bevel Cutting

Position

Raise the arm to allow the saw blade sufficient clearance above

the table top. Release the bevel clamp handle (A) and pull the

bevel index pin. The motor can now be moved to a bevel posi-

tion as indicated on the bevel scale. Lock the motor by releas-

ing the bevel index pin (possible only at 0

, 45

and 90

) and

by locking the bevel clamp handle.

Cross Cutting

Lock the arm in the 0

position. Place the material

securely against the guide strip– keep hands well away

from the blade. Draw the saw blade across the mate-

rial. After the cut has been completed return the blade

behind the guide strip. Observe this order of operation

for all cross cuts. Never push the saw blade into the

material. Pull the blade slowly and firmly across the

material from the rear of the arm using the operating

handle. The saw blade should cut into the table about

1/ 16” when cutting through the material. Raise the

anti-kickback to just clear the material being cut.

Adjust for varying wood thickness or warped material.

In Rip—Out Rip

When ripping the arm should be locked in a cross cut position. Pull the motor to the end of the arm. Release the yoke clamp

handle by pulling forward and lift the rip index pin. Revolve motor 90

right or left for out-rip or in-rip position. Engage rip

index pin and lock yoke clamp handle. Locate saw for desired width of rip and lock saw carriage by tightening riplock against

side of arm. Rotate guard so the in-feed side almost touches the material. Lower anti-kickback assembly so the fingers are

approximately 1/8” lower than the material. Place material against the guide strip and feed evenly into the saw blade. Use

push board on narrow work. Never place hands between blade and guide fence. Do not force material and DO NOT feed

from the kickback side of the guard. Serious injury could result. Follow instructions on caution tag.

!!! DANGER !!!

!!! DANGER !!! !!! DANGER !!!

!!! DANGER !!!

NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT

NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT

NEVER FEED MATERIAL FROM THE KICKBACK SIDE OF THE GUARD. SERIOUS INJURY COULD RESULT.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios

DeWalt DC841 Instrucciones de operaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares DeWalt DC841