DeWalt DC841 Instrucciones de operaciones descargar pdf (Pagina 8)

Operating Instructions

!!! CAUTION !!!

BOTH UPPER AND LOWER GUARDS MUST REMAIN IN PLACE FOR SAFE CUTTING OPERATION.

Control Locations

A. Rip Index Pin

B. Miter Latch Handle

C. Arm Clamp Handle

D. Elevating Control Handle

E. Miter Scale

F. On/Off Switch

G. Adjustable Arm Stop

H. Yoke Clamp Handle

I. Operating Handle

J. Bevel Index Pin

K. Bevel Scale

L. Bevel Clamp Handle

M. Anti Kickback Assembly

N. Serial Number Plate

O. Riplock

P. Rip Scale

Moving the Arm Horizontally and Vertically

The elevating crank is used to raise or lower the arm to accommodate cutting operations (see below left). Do not adjust the

height of the saw while the motor is running. Change the position of the arm for miter cutting is done by pulling the arm

clamp handle (A) forward and lifting the miter latch handle (B). Observing the miter scale, swing the arm either right or left

to the desired angle. The arm can quickly be located at the 0

and 45

marks by using the indexing slots machined into the

column ring. When you have located the saw at the required position engage both the miter latch and the arm clamp.

Revolving the Yoke Horizontally on

the Arm

Pull the saw carriage to the front of the arm and lock into

position with the riplock. Pull the yoke clamp handle

forward and lift the rip index pin. The yoke and motor

can now be turned either right or left for rip cuts. When

you have located the yoke motor in the required posi-

tion, engage the rip index and push the yoke clamp

back.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sin comentarios

DeWalt DC841 Instrucciones de operaciones Pagina 8